ThermaSheet Wedge / Shower Trays
Our shower trays are designed to make the tiling of walk-in showers simple.
They are ideally suited for projects where falls to floor need to be created over existing level floors in environments such as wet rooms, balconies, roof terraces etc. A tough surface coating provides the perfect surface for the application of tiles. Creating accurate falls over long distances is easily achieved by using ThermaSheet as a raising course. Our predetermined boards have a fall of 25 – 10 mm.
50% reduction in heat up time therefore reducing energy consumption and saving on running costs. Achieving higher temperatures as no energy absorbed by the concrete slab.
Tile Ready Service
Provides a perfect base on which to apply finishes such as tiles, synthetic renders, decorative plaster and much more. With the tile ready surface it makes construction projects easier.
Resistant to water making ThermaSheet ideal for use in areas that are subject to prolonged or permanent water immersion. Uses include, wetrooms, showers, external walls, balconies and patios, garden water features etc.
The boards are extremely lightweight and easy to manoeuvre, making projects less demanding and saving time on the job as a whole.
Enhances Floor Heating
Creating a large radiating heat surface. Heat source temperatures can be lower and creates an added benefit of the heat source spread throughout the whole room reducing heating bills.
Internal - External Use
Given its waterproofing and insulation properties, ThermaSheet is particularly useful in both internal and external wet areas exposed to moisture.
Range of Sizes
Typically, 10mm is used on the floors and 12.5mm on the walls, but our boards range from 6mm right through to 50mm to suit any project.
High Compressive Strength
More strength thanks to the extra bond between the cement mortar and the reinforcing fiber glass mesh Compressive strength rate 300k/Pa (30 tonnes/m2)
Can be cut easily using a sharp Stanley knife or a fine saw
ThermaSheet is environmentally friendly, it is CFC and HCFC free.
Render + Plaster Ready Service
This rigid foam core is reinforced on both sides with a fibreglass mesh, plus a top layer of polymerised cementitious mortar, making it an ideal surface for tile adhesive and render.
Our High Performance Construction Boards are the ideal solution where impact sound reduction is of particular importance. Designed for tiled floor areas where noise is an issue, it’s low mass helps absorb impact sound energy, giving enhanced acoustic performance.